Searching for existing POIs

You can use the Information panel of POIs' Form to search for specific POIs applying the corresponding filters on the form's fields. The search results are displayed on the information table when the search procedure is completed.

 

If you want to display the information of all the stored POIs, you have to prepare a simple selection without adding any field's filter as described below.

1.  Go to the Information panel and set all  the "filter" icons in inactive mode . This action will remove all the applied  filters.

2.  Click on the "search" icon placed on the bottom of the panel. The system returns the data of all the existing POIs on the information table.

3.  To show or hide the POIs icons on the map check or uncheck the   check box.

 

You can prepare a advance searching with one or more criteria, adding filters to POIs characteristics (form's fields). For a search based on criteria follow the steps below.

1.  Go to the Information panel and type on a data input field the value based on which you want to filter the searching. For example, type/choose "hotel" on the Category field to search for the hotel POIs.

2.  Click on the inactive (grey) "filter" icon  placed next to the selected field(s), to make it active (Blue colored).  You can add more than one criteria activating the corresponding field's filters.

3.  Click on the "search" icon placed on the bottom of the panel. The system returns the data of the POIs that meet the criteria.

 

To prepare a search based on a particular field value you can type the value on the selected field and click on the "search with specified field" icon , placed next to the field.

In this case is not necessary to activate the "filter" icon of the selected field.